LEGO1 Simplex — 1966 Ferrari 365 P2 — Real-Build Plan Generator

Chassis architecture: mid-engine prototype with low nose, open cockpit, long rear deck. Primary LEGO translation: Technic spine + plate-box frame, stud-grid outer shell, tile-smoothed red body, black aero/trim, low-profile stance. Dimensional lock (8-wide): target 8w body, 10–11 studs wheelbase, 3.5–4 bricks height including windscreen line. All offsets must be legal (half-stud only via sanctioned parts), all axles straight. Compliance lock: BrickLink Studio collision check required; all connections must be legal clutch connections; no forced bending; no pin-in-stress; no illegal SNOT thickness stacking.

1) Click Generate. 2) In the Parts panel, use filters as needed. 3) Copy the BOM (either full BOM source or filtered parts). 4) In BrickLink Studio: open a new file → open the Parts Palette → import wanted list / XML (or paste plain list into a wanted-list converter), then place parts from the palette while following Level 4 instructions exactly. 5) Build workflow note: after every major module (chassis, front clip, cockpit, rear clip), run collision check and connection validation; do not proceed until the module is collision-free and fully connected with no floating parts.